買った後にそのまま放置されていたSwitchの設定が終わらないです。
というか設定コマンドがよくわからないのが多くて。。。。
SwitchはCiscoの2940。
とりあえず全Portシャットダウンしたのでこれから必要な設定を少しずつやっていく予定。
できれば早いうちに今使っているcoregaのやつから置き換えたいけどねぇ。。。。
Interfaceの設定項目がわからんのですよ。。。。
arp Set arp type (arpa, probe, snap) or timeout
bandwidth Set bandwidth informational parameter
carrier-delay Specify delay for interface transitions
cdp CDP interface subcommands
channel-group Etherchannel/port bundling configuration
channel-protocol Select the channel protocol (LACP, PAgP)
default Set a command to its defaults
delay Specify interface throughput delay
description Interface specific description
dot1x Interface Config Commands for 802.1x
down-when-looped Force looped interface down
duplex Configure duplex operation.
exit Exit from interface configuration mode
fair-queue Enable Fair Queuing on an Interface
help Description of the interactive help system
hold-queue Set hold queue depth
ip Interface Internet Protocol config commands
keepalive Enable keepalive
lacp LACP interface subcommands
load-interval Specify interval for load calculation for an interface
logging Configure logging for interface
mac-address Manually set interface MAC address
macro Command macro
mdix Set Media Dependent Interface with Crossover
mls mls interface commands
mvr MVR per port configuration
no Negate a command or set its defaults
pagp PAgP interface subcommands
random-detect Enable Weighted Random Early Detection (WRED) on an
Interface
rmon Configure Remote Monitoring on an interface
shutdown Shutdown the selected interface
snmp Modify SNMP interface parameters
spanning-tree Spanning Tree Subsystem
speed Configure speed operation.
storm-control storm configuration
switchport Set switching mode characteristics
timeout Define timeout values for this interface
transmit-interface Assign a transmit interface to a receive-only interface
tx-ring-limit Configure PA level transmit ring limit
udld Configure UDLD enabled or disabled and ignore global UDLD
setting
少しずつ調べながらやっていかないとね。